Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014659 NAVIGATION / MULTI INFO DISPLAY _0074553 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation ECU sub-assembly via this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM

E229861E47
0.854,0.802 1.583,1.219 0.729,0.417 10 false AUXO 0.927,1.281 1.479,1.625 0.552,0.344 10 false ARO 0.948,1.76 1.375,1.917 0.427,0.156 10 false ALO 0.833,2.24 1.479,2.521 0.646,0.281 10 false ASGN 0.844,2.708 1.448,3.052 0.604,0.344 10 false AGND 2.49,2.833 3.146,2.99 0.656,0.156 10 false (Shielded) 4.01,2.854 4.667,3.01 0.656,0.156 10 false (Shielded) 5.927,0.802 6.49,1.073 0.563,0.271 10 false ADPG 5.927,1.292 6.354,1.448 0.427,0.156 10 false VAR+ 5.677,0.688 6.01,1.094 0.333,0.406 10 false 25 5.667,1.167 6.01,1.51 0.344,0.344 10 false 26 5.667,1.646 5.969,1.896 0.302,0.25 10 false 28 5.677,2.115 5.969,2.344 0.292,0.229 10 false 27 5.667,2.604 5.938,2.802 0.271,0.198 10 false 11 1.333,0.677 1.51,0.833 0.177,0.156 10 false 9 1.333,1.156 1.583,1.417 0.25,0.26 10 false 6 1.333,1.615 1.51,1.771 0.177,0.156 10 false 7 1.344,2.083 1.521,2.24 0.177,0.156 10 false 8 1.323,2.542 1.5,2.698 0.177,0.156 10 false 10 0.302,3.104 0.76,3.344 0.458,0.24 10 false I146 0.302,3.26 1.49,3.688 1.188,0.427 10 false No. 1 Stereo Jack Adapter Assembly 5.792,3.26 6.802,3.573 1.01,0.313 10 false Navigation ECU Sub-assembly 5.927,1.729 6.354,1.885 0.427,0.156 10 false VAL+ 5.927,2.177 6.354,2.333 0.427,0.156 10 false VA- 5.927,2.698 6.594,3.031 0.667,0.333 10 false AGND 5.792,3.104 6.26,3.51 0.469,0.406 10 false I67

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.
E227392C07
1.5,0.219 1.896,0.5 0.396,0.281 1.51,2.271 1.906,2.521 0.396,0.25 2.115,1.417 2.781,1.177 false 2.219,1.635 2.073,1.958 false 2.115,1.635 1.594,1.958 false 2.448,1.635 2.969,1.958 false 2.333,1.635 2.479,1.958 false 1.583,3.875 1.177,4.229 false 1.875,3.875 2.271,4.229 false 2.052,3.833 2.5,3.833 false 1.406,3.833 0.885,3.833 false 1.729,3.875 1.729,4.417 false 2.823,1.083 3.427,1.479 0.604,0.396 10 false AGND 1.813,1.979 2.365,2.229 0.552,0.25 10 false VAR+ 1.177,1.979 1.719,2.25 0.542,0.271 10 false ADPG 2.885,1.979 3.333,2.229 0.448,0.25 10 false VAL+ 2.417,1.979 2.833,2.24 0.417,0.26 10 false VA- 0.177,0.167 0.667,0.792 0.49,0.625 10 false *a 1.615,0.281 1.885,0.438 0.271,0.156 10 false I67 2.531,3.76 3.104,4.094 0.573,0.333 10 false AGND 0.927,4.26 1.344,4.5 0.417,0.24 10 false ALO 2.156,4.26 2.646,4.469 0.49,0.208 10 false AUXO 0.177,2.26 0.656,2.698 0.479,0.438 10 false *b 0.458,3.729 1.01,4.031 0.552,0.302 10 false ARO 1.49,4.427 2.01,4.615 0.521,0.188 10 false ASGN 1.594,2.323 2.063,2.604 0.469,0.281 10 false I146
*a Front view of wire harness connector
(to Navigation ECU Sub-assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Disconnect the navigation ECU sub-assembly connector.


b.

Disconnect the No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I67-25 (ADPG) - I146-9 (AUXO) Always Below 1 Ω
I67-26 (VAR+) - I146-6 (ARO) Always Below 1 Ω
I67-28 (VAL+) - I146-7 (ALO) Always Below 1 Ω
I67-27 (VA-) - I146-8 (ASGN) Always Below 1 Ω
I67-11 (AGND) - I146-10 (AGND) Always Below 1 Ω
I67-25 (ADPG) - Body ground Always 10 kΩ or higher
I67-26 (VAR+) - Body ground Always 10 kΩ or higher
I67-28 (VAL+) - Body ground Always 10 kΩ or higher
I67-27 (VA-) - Body ground Always 10 kΩ or higher
I67-11 (AGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR