This circuit is used when the voice guidance in the navigation system is on.
Using this circuit, the navigation ECU sub-assembly sends the signals to the stereo component amplifier assembly.
Disconnect the navigation ECU sub-assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| I65-2 (RL+) - I69-15 (II1+) | Always | Below 1 Ω |
| I65-6 (RL-) - I69-14 (II1-) | Always | Below 1 Ω |
| I69-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| I65-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| I65-6 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG