Home › Engine / Hybrid System › 2GR-FE FUEL › FUEL PUMP ECU › from 2013.07
RM2030EQ _51 Engine / Hybrid System _014636 2GR-FE FUEL _0074424 FUEL PUMP ECU A

2GR-FE FUEL  FUEL PUMP ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64711 3.REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Hide 58387 4.REMOVE REAR FLOOR FINISH PLATE

Hide 64725D 5.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64722 6.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH

Hide 89570A 7.REMOVE FUEL PUMP CONTROL ECU ASSEMBLY

a.
A283936

Remove the 2 nuts.


b.

Disconnect the fuel pump control ECU assembly connector and remove the fuel pump control ECU assembly.

NOTICE:

Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.


HINT:

If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU assembly, damaging its internal parts. Make sure to replace the fuel pump control ECU assembly at the same time when replacing the fuel pump.