1.INSPECT TIRES
Check the tires for wear and proper inflation pressure.
| Tire Size | Front | Rear |
|---|---|---|
| 215/60R16 95V
215/55R17 94V |
240 kPa (2.4 kgf/cm2, 35 psi) | |
| Tire Size | Front | Rear |
|---|---|---|
| 215/60R16 95V | 210 kPa (2.1 kgf/cm2, 30 psi) | |
| 215/55R17 93V | 220 kPa (2.2 kgf/cm2, 32 psi) | |
Using a dial indicator, check the runout of the tires.
1.4 mm (0.0551 in.)
2. ROTATE TIRES
|
Front |
If the spare tire uses a different type of wheel than the other tires, rotate the tires as shown by (A) in the illustration. If the spare tire has the same type of wheel as the other tires, rotate the tires, including the spare tire, as shown by (B) in the illustration.
3.INSPECT AND ADJUST WHEEL BALANCE
Inspect and adjust the off-the-car balance.
Steel wheel:
8.0 g (0.0176 lb)
| *a | 25 mm (0.984 in.) |
Others (Non-steel wheel):
8.0 g (0.0176 lb)
Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
Do not touch the adhesive surface of the balance weight.
Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.
Push the balance weight with your finger to securely adhere it to the desired position.
Do not reuse balance weights.
Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.
4.INSPECT FRONT AXLE HUB BEARING
5.INSPECT REAR AXLE HUB BEARING