Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › from 2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074736 LIGHTING SYSTEM L

LIGHTING (EXT)  LIGHTING SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected:

System See Procedure
Parking Assist Monitor System (Click here)



EXPRESSIONS OF IGNITION SWITCH


The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Switch Type
Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off
Ignition Switch ACC ACC On (ACC)
Ignition Switch to ON ON On (IG)
Engine Start START Start


PRECAUTION FOR HEADLIGHT BULB REPLACEMENT


a.

If even a thin film of oil is left on the surface of a halogen bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand does not contact the glass part of the bulb.


b.

Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.


c.

Always replace a bulb with another bulb of the same wattage.


d.

If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.


e.

Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may be filled with water through gaps around the socket if it is not installed securely.



PRECAUTION FOR LIGHT BULB REPLACEMENT


a.

This vehicle is equipped with an engine room junction block assembly (semiconductor type) as a device to cut off a circuit if there is an overcurrent. When there is too much current, the engine room junction block assembly does not melt like a fuse, but instead opens and returns to normal when the ignition switch is turned off. Therefore, if a bulb connected to the engine room junction block assembly is replaced with a non-genuine bulb or a bulb that is not designed for the vehicle, the bulb may not function as the current may be cut off.