Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0164667 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM J

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  LVL Terminal Circuit  


DESCRIPTION

By connecting terminals LVL and CG of the DLC3, the headlight leveling ECU assembly initializes the height control sensor signal.

WIRING DIAGRAM

E136349E34
0.885,0.688 1.156,0.854 0.271,0.167 10 false LVL 0.927,1.354 1.167,1.521 0.24,0.167 10 false CG 1.25,0.604 1.375,0.76 0.125,0.156 10 false 8 1.25,1.25 1.375,1.406 0.125,0.156 10 false 4 0.615,2.667 0.854,2.833 0.24,0.167 10 false I39 0.615,2.833 1.031,3 0.417,0.167 10 false DLC3 5.615,2.74 5.958,2.927 0.344,0.188 10 false A78 5.615,2.906 7.115,3.26 1.5,0.354 10 false Headlight Leveling ECU Assembly 5.99,0.688 6.385,0.865 0.396,0.177 10 false SPDL 5.813,0.573 5.927,0.74 0.115,0.167 10 false 5

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A78 headlight leveling ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A78-5 (SPDL) - I39-8 (LVL) Always Below 1 Ω
A78-5 (SPDL) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I39-4 (CG) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR