Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0164667 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM T

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Automatic Headlight Beam Level Control
Symptom Suspected Area Link
"Check Headlight System" is displayed on the multi-information display (headlight leveling control is normal) Headlight beam level warning circuit Click here
Headlight leveling ECU assembly Click here
Headlight beam level control does not operate Check the FAIL-SAFE function Click here
Check DTCs Click here
Headlight leveling ECU power source circuit Click here
Headlight signal circuit Click here
Headlight beam level control actuator circuit Click here
Speed signal circuit Click here
Headlight leveling ECU assembly Click here
DTC information cannot be detected Diagnosis circuit Click here
Headlight leveling ECU assembly Click here
Initialization cannot be performed Check DTCs Click here
LVL terminal circuit Click here
Headlight leveling ECU assembly Click here

NOTICE:
·

Initialize the headlight leveling ECU assembly (set the zero point of the rear height control sensor sub-assembly in the headlight leveling ECU assembly) after the vehicle height changes due to replacement of suspension components or after performing operations such as removal and reinstallation or replacement of the rear height control sensor sub-assembly.

·

Initialize the headlight leveling ECU assembly when the headlight leveling ECU assembly is replaced.