Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0164667 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM J

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  Headlight Beam Level Warning Circuit  


DESCRIPTION

The headlight leveling ECU assembly sends a warning display signal to the combination meter assembly if it detects a malfunction in the headlight beam level control system. When the combination meter assembly receives the warning display signal, it alerts the driver by displaying "Check Headlight System" on the multi-information display.

WIRING DIAGRAM

E303355E08
0.354,2.458 1.396,2.667 1.042,0.208 10 false from IG2 Relay 1.156,0.979 1.99,1.219 0.833,0.24 10 false METER-IG2 2.49,1.26 4.406,1.5 1.917,0.24 10 false Combination Meter Assembly 5.365,2.833 6.813,3.24 1.448,0.406 10 false Headlight Leveling ECU Assembly 2.292,0.823 2.625,1.031 0.333,0.208 10 false I18 3.688,0.813 4.208,1.052 0.521,0.24 10 false LVWG 5.781,0.823 6.302,1.063 0.521,0.24 10 false WNG 5.365,2.656 5.719,2.854 0.354,0.198 10 false A78 2.625,0.823 3.146,1.063 0.521,0.24 10 false IG+ 4.271,0.823 4.604,1.031 0.333,0.208 10 false I17 5.594,0.719 5.802,0.906 0.208,0.188 10 false 6 2.281,0.615 2.542,0.823 0.26,0.208 10 false 13 4.271,0.615 4.531,0.823 0.26,0.208 10 false 11

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HEADLIGHT LEVELING ECU ASSEMBLY
a.

Disconnect the A78 headlight leveling ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A78-6 (WNG) - Body ground Engine switch on (IG) 11 to 14 V
A78-6 (WNG) - Body ground Engine switch off Below 1 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the I17 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A78-6 (WNG) - I17-11 (LVWG) Always Below 1 Ω
A78-6 (WNG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR