Use the same procedure for the 3 spoke and 4 spoke.
The procedure listed below is for the 3 spoke.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
3.REMOVE LOWER NO. 3 STEERING WHEEL COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 3 steering wheel cover.
45186
4.REMOVE LOWER NO. 2 STEERING WHEEL COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 2 steering wheel cover.
45130
5.REMOVE HORN BUTTON ASSEMBLY
When storing the horn button assembly, keep the airbag deployment side facing upward.
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Torsion Spring |
Using a screwdriver, push in the 3 torsion springs to disengage the 3 pins as shown in the illustration.
Do not drop the horn button assembly.
Insert the screwdriver from the installation holes for the lower No. 3 steering wheel cover and lower No. 2 steering wheel cover.
Pull out the horn button assembly from the steering wheel assembly and hold the horn button assembly with one hand.
When separating the horn button assembly, do not pull the airbag wire harness.
| *a | Airbag Connector |
| *b | Horn Connector |
| *c | Airbag Connector Lock |
| *d | Protective Tape |
Disconnect the horn connector from the horn button assembly.
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
Disconnect the airbag connector to remove the horn button assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.