Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2015.04
RM2030EQ _51 Engine / Hybrid System _014642 CRUISE CONTROL _0165902 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA8  Front Camera Module Incorrect Axial Gap  C1AA9  Front Camera Module Beam Axis Not Adjusted  


DESCRIPTION

If the lane departure warning camera determines that the lane departure warning camera axis has deviated, DTC C1AA8 is stored. Also, if the camera axis adjustment is not performed after installing the lane departure warning camera, DTC C1AA9 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA8 Front Camera Module Incorrect Axial Gap While the engine switch is on (IG) and the lane departure alert system is operating, the lane departure warning camera detects lane departure warning camera axis deviation.
·

Lane departure warning camera

·

Windshield glass


C1AA9 Front Camera Module Beam Axis Not Adjusted While the engine switch is on (IG), the lane departure warning camera detects that lane departure warning camera adjustment has not been completed. Lane departure warning camera

CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.CHECK CAMERA INSTALLATION (LANE DEPARTURE WARNING CAMERA)
a.

Check the lane departure warning camera installation.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>INSTALLATION

HINT:

If the lane departure warning camera bracket is deformed or misaligned, replace the windshield glass.

Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD GLASS>REMOVAL


Result:
Result Proceed to
The lane departure warning camera bracket is not deformed or misaligned A
The lane departure warning camera bracket is deformed or misaligned B




A

2.ADJUST LANE DEPARTURE WARNING CAMERA

B

2.ADJUST LANE DEPARTURE WARNING CAMERA
a.

Perform the lane departure warning camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCS (LANE DEPARTURE ALERT SYSTEM)
3.CHECK FOR DTCS (LANE DEPARTURE ALERT SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR

Chassis > Lane Departure Alert > Clear DTCs
50002 355

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR

Chassis > Lane Departure Alert > Trouble Codes
50001 355
Result:
Result Proceed to
DTC C1AA8 and C1AA9 are not output A
DTC C1AA8 or C1AA9 is output B




A

END (AXIS WAS MISALIGNED)

B