Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › from 2015.04
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074561 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 88162 2.REMOVE BLIND SPOT MONITOR SENSOR (for LH Side)

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.


a.
E226447

Disengage the 2 clamps.


b.
E226449

Remove the 3 nuts.


c.
E267787

Disconnect the connector to remove the blind spot monitor sensor.


Hide 88162 3.REMOVE BLIND SPOT MONITOR SENSOR (for RH Side)

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.


a.
E226448

Disengage the clamp.


b.
E266119

Remove the 3 nuts.


c.
E226450

Disconnect the connector to remove the blind spot monitor sensor.


Hide 88173 4.REMOVE BLIND SPOT MONITOR COVER LH

a.
E226407

Remove the 2 nuts.


b.

Disengage the claw to remove the blind spot monitor cover LH.


Hide 88163 5.REMOVE BLIND SPOT MONITOR COVER RH

HINT:

Use the same procedure as for the LH side.