Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › from 2015.04
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074561 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


PROCEDURE

Hide 88173 1.INSTALL BLIND SPOT MONITOR COVER LH

a.

Engage the claw.


b.

Install the blind spot monitor cover LH with the 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88163 2.INSTALL BLIND SPOT MONITOR COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 88162 3.INSTALL BLIND SPOT MONITOR SENSOR (for LH Side)

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.


a.

Connect the connector.


b.

Install the blind spot monitor sensor with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Engage the 2 clamps.


Hide 88162 4.INSTALL BLIND SPOT MONITOR SENSOR (for RH Side)

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.


a.

Connect the connector.


b.

Install the blind spot monitor sensor with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Engage the clamp.


Hide 5.INSTALL REAR BUMPER ASSEMBLY

Hide 6. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

Hide 7. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION