The following inspection procedures for the parking assist monitor system are based on the assumption that the navigation system*1 or audio and visual system (for Radio and Display Type)*2 is normal. If the navigation system*1 or audio and visual system (for Radio and Display Type)*2 has any malfunctions, first proceed with troubleshooting the navigation system*1 or audio and visual system (for Radio and Display Type)*2.
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
*1: w/ Navigation System
*2: w/o Navigation System
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
*1: w/ Navigation System
*2: w/o Navigation System
*3: for 3 Spoke
*4: for 4 Spoke