1. PRECAUTION
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53922B
3.REMOVE FRONT PANEL GARNISH LH
53921B
4.REMOVE FRONT PANEL GARNISH RH
55405B
5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55660
6.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
58831A
7.REMOVE FRONT CONSOLE UPPER PANEL GARNISH
8.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
|
Protective Tape |
Apply protective tape to the area shown in the illustration.
Remove the 4 bolts.
Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 6 clips.
Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.
86211
9.REMOVE NO. 1 RADIO BRACKET
Remove the 5 screws and No. 1 radio bracket.
86212
10.REMOVE NO. 2 RADIO BRACKET
Remove the 5 screws and No. 2 radio bracket.
55900
11.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
86120L
12.REMOVE NAVIGATION RECEIVER ASSEMBLY