This DTC is stored when the blind spot monitor sensor LH detects a +B short in the outer rear view mirror indicator LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB1 | Short to +B in Outer Mirror Indicator(Slave) | Both of the following conditions are met:
·
Blind spot monitor main switch (warning canceling switch assembly) is on. ·
The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time. |
·
Outer mirror LH ·
Mirror sub-assembly LH ·
Wire harness or connector ·
Blind spot monitor sensor LH ·
Outer mirror control ECU assembly LH |
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the T24 blind spot monitor sensor LH connector.
| *a | Front view of wire harness connector
(to Blind Spot Monitor Sensor LH) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T24-4 (OMIL) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the IND2 outer mirror LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T24-4 (OMIL) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the z5 outer mirror control ECU assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T24-4 (OMIL) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K12 outer mirror control ECU assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T24-4 (OMIL) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG