Home › Brake › BRAKE (FRONT) › FRONT BRAKE › from 2015.04
RM2030EQ _54 Brake _014652 BRAKE (FRONT) _0074518 FRONT BRAKE G

BRAKE (FRONT)  FRONT BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the disc brake cylinder assembly and/or front disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C143462C01
2.349,1.243 2.516,1.402 0.167,0.159 10 *1 1.651,0.777 2.21,1.336 2.21,1.336 2.336,1.336 false
*1 Ruler


Using a ruler, measure the pad lining thickness.

Standard thickness:

12.0 mm (0.472 in.)


Minimum thickness:

2.0 mm (0.0787 in.)


If the pad lining thickness is less than the minimum, replace the front disc brake pads.

HINT:

Be sure to check the wear of the front disc when replacing the front disc brake pads.



Hide 3.INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the front disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are cleaned off.

If necessary, replace the front disc brake pad support plates.


Hide 4.INSPECT DISC THICKNESS

a.
C246334C01
1.951,1.885 2.11,2.029 0.159,0.144 10 *1 1.642,1.756 1.839,1.954 1.839,1.954 1.931,1.954 false
*1 Micrometer


Using a micrometer, measure the disc thickness.

Standard thickness:

28.0 mm (1.10 in.)


Minimum thickness:

25.0 mm (0.984 in.)


If the disc thickness is less than the minimum, replace the front disc.


Hide 5.INSPECT DISC RUNOUT

a.

Inspect the front axle hub bearing looseness and front axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION


b.
C239573N02
1.25,1.677 1.125,1.885 1.125,1.885 0.656,1.885 true 0.365,1.813 0.667,1.969 0.302,0.156 10 false SST

Using SST to hold the disc, tighten the disc with the 5 nuts.

SST
09330-00021  

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)


c.
C239574C04
2.438,1.521 2.125,1.521 2.125,1.521 1.938,1.271 true 2.5,1.458 2.656,1.615 0.156,0.156 10 false *1
*1 Dial Indicator


Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


NOTICE:

Keep the magnet of the dial indicator away from the axle hub and speed sensor.


If the runout exceeds the maximum value, change the installation position of the disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.


d.

Remove the 5 nuts and front disc.