1.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
2.REMOVE REAR SEAT CUSHION LOCK HOOK
3.REMOVE REAR SIDE SEATBACK ASSEMBLY LH
4.REMOVE REAR SIDE SEATBACK ASSEMBLY RH
5.REMOVE REAR SEATBACK ASSEMBLY LH
6.REMOVE REAR SEATBACK ASSEMBLY RH
7.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH (for LHD)
8.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH (for RHD)
73480
9.DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for LHD)
73480
10.DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for RHD)
73370C
11.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly LH.
73360C
12.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly RH.
62332A
13.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH.
62331A
14.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Disconnect the rear door opening trim weatherstrip RH.
62472A
15.REMOVE ROOF SIDE INNER GARNISH LH
62471A
16.REMOVE ROOF SIDE INNER GARNISH RH
Use the same procedure as for the LH side.
73373
17.REMOVE REAR SEAT SHOULDER BELT COVER
Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.
Use the same procedure for the other 2 rear seat shoulder belt covers.
64330
18.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Disconnect the connector.
| *a | Protective Tape |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
Tape the tips of pliers before use.
Disengage the 5 guides.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
64330
19.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
| *a | Protective Tape |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
Tape the tips of pliers before use.
Disengage the guide.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
73370C
20.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt.
Disengage the guide to remove the rear No. 1 seat outer belt assembly LH.
73360C
21.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.