Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › THROTTLE BODY
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074874 THROTTLE BODY A

2AR-FXE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A265350

Disconnect the mass air flow meter connector and wire harness clamp from the air cleaner cap sub-assembly.


b.

Disconnect the ventilation hose from the cylinder head cover.


c.

Disconnect the connector and wire harness clamp.


d.
A259031

Release the 2 clamps and remove the air cleaner cap sub-assembly.


e.

Disconnect the 2 fuel vapor feed hoses.

A306179
4.354,0.865 4.677,0.865 false 5.167,0.583 5.49,0.583 false 5.313,1.802 5.552,1.583 5.552,1.583 5.823,1.583 true 4.156,2.583 4.427,2.583 4.427,2.583 4.656,2.448 false 5.521,2.302 5.719,2.563 5.719,2.563 5.99,2.563 false 4.531,1.521 4.719,1.521 4.719,1.521 4.719,1.823 true 4.198,0.771 4.51,0.927 0.313,0.156 10 false *1 5.531,0.51 5.844,0.667 0.313,0.156 10 false *2 6.042,2.479 6.354,2.635 0.313,0.156 10 false *3 4.365,1.427 4.677,1.583 0.313,0.156 10 false *4 4.281,0.208 4.594,0.365 0.313,0.156 10 false *a 5.031,1.083 5.344,1.24 0.313,0.156 10 false *b 5.875,1.5 6.188,1.656 0.313,0.156 10 false *1 3.979,2.5 4.292,2.656 0.313,0.156 10 false *2 5.417,0.219 5.729,0.375 0.313,0.156 10 false *a
*1 Retainer *2 Fuel Tube Connector
*3 Pipe *4 O-ring
*a Pinch *b Pull


NOTICE:
·

Remove any dirt or foreign matter on the fuel tube connector before performing this work.

·

Do not damage or allow foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the pipe.

·

Perform this work by hand. Do not use any tools.

·

Protect the disconnected parts by covering them with plastic bags after disconnecting each fuel vapor feed hose.




f.
A259033

Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.


Hide 22030 4.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

a.
A259034

Disconnect the 2 hoses.


b.
A259035

Disconnect the throttle body connector.


c.

Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.


d.
A259045

Remove the 4 bolts and the throttle with motor body assembly and fuel tube bracket.


e.
A259036

Remove the gasket from the intake manifold.