Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › ECM › 2012.02–2015.04
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074875 ECM A

2AR-FXE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 89661 4.REMOVE ECM

a.
A254787

Disconnect the 2 ECM connectors.

i.

Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.




b.
A254792E01
2.49,0.74 2.615,0.896 0.125,0.156 10 A 2.396,1.198 2.521,1.354 0.125,0.156 10 B

Remove the nut.


c.

Remove the screw (A).


d.

Loosen the screw (B) and remove the ECM.


e.

Remove the screw (B).


f.
A254793

Remove the 2 screws and No. 2 ECM bracket.


Hide 82662A 5.REMOVE NO. 1 RELAY BLOCK COVER

Hide 89667E 6.REMOVE NO. 1 ECM BRACKET

a.
A259046

Remove the nut.


b.

Release the 2 clamps and disconnect the wire harness.


c.
A254786

Disconnect the wire harness clamp.


d.
A249913

Remove the nut and No. 1 ECM bracket.