Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › MASS AIR FLOW METER
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074876 MASS AIR FLOW METER G

2AR-FXE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedure below.

·

Only replace the mass air flow meter when the mass air flow value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use an exhaust air duct to perform suction on the exhaust pipe.



a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG) (do not run the engine).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

e.

Wait 30 seconds, and read the values on the intelligent tester.

Standard:
Item Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after turning power switch on (IG)


0.49g/sec. or less


If the result is not as specified, replace the mass air flow meter sub-assembly.

If the result is as specified, inspect the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION