Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › 2012.02–2015.04
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074877 CAMSHAFT POSITION SENSOR A

2AR-FXE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Clean and degrease the threads of the bolt for the camshaft position sensor.


b.
A158220

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:

Make sure that the O-ring is not cracked or moved out of place during installation.



c.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the sensor connector.


Hide 2.INSPECT FOR OIL LEAK

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY