Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074880 ENGINE COOLANT TEMPERATURE SENSOR A

2AR-FXE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.

Connect the engine coolant temperature sensor connector.


d.

Install the wire harness with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Connect the ventilation hose to the cylinder head cover.


Hide 17750A 2.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 53295E 3.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 5.INSPECT FOR COOLANT LEAK (for Engine)

Hide 12601B 6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY