1.DRAIN COOLANT (for Engine)
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
53295E
3.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
4.REMOVE INLET AIR CLEANER ASSEMBLY
89422
5.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the ventilation hose from the cylinder head cover.
Disconnect the engine coolant temperature sensor connector.
Remove the 2 bolts and disconnect the wire harness.
| *1 | Ball Joint Lock Nut Wrench |
| *2 | Gasket |
Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
Remove the gasket from the engine coolant temperature sensor.