Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › KNOCK SENSOR
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074881 KNOCK SENSOR A

2AR-FXE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

a.
A212473
1.042,2.698 1.375,2.927 0.333,0.229 10 false *c 1.042,2.875 1.375,3.104 0.333,0.229 10 false *d 1.813,2.125 2.01,2.323 0.198,0.198 10 true *b 2.625,2.771 2.813,2.99 0.188,0.219 10 false *a
*a Front of Engine
*b Up
*c 7°
*d 10°


Install the sensor with the bolt so that the sensor is angled as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.


HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



b.

Connect the sensor connector.