Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074891 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  INSTALLATION  


PROCEDURE

Hide G9040 1.INSTALL WATER PUMP WITH MOTOR ASSEMBLY

a.
A259441
0.875,1.615 0.656,1.688 false 0.896,1.927 0.656,1.875 false 0.167,0.427 0.406,0.625 0.24,0.198 10 *c 1.083,1.677 1.323,1.875 0.24,0.198 10 *d 0.854,1.5 1.094,1.698 0.24,0.198 10 *a 0.896,1.875 1.135,2.073 0.24,0.198 10 *b
*a Rib
*b Alignment Mark
*c 90°
*d 2 to 7 mm (0.0787 to 0.276 in.)


Connect the water hose.

NOTICE:
·

Make sure that the clip is positioned as shown in the illustration.

·

Make sure to align the alignment marks of the hoses with the ribs of the inverter water pump assembly.

·

Do not remove the pieces of cloth or plastic bags from the pipe and disconnected hose until installation.




b.

Install the water pump with motor assembly with the 3 bolts.

Torque:
6.1 N*m (62 kgf*cm, 54 in.*lbf)

NOTICE:

Do not hold the water pump with motor assembly by the connector terminals when removing or installing it.



c.

Connect the connector.


d.
A259440
0.594,1.5 0.375,1.448 false 0.635,1.323 0.771,1.292 false 0.219,1.365 0.396,1.646 0.177,0.281 10 *a 0.792,1.229 0.969,1.51 0.177,0.281 10 *b 0.375,0.177 0.552,0.458 0.177,0.281 10 *c 1,1.396 1.177,1.677 0.177,0.281 10 *d
*a Rib
*b Alignment Mark
*c 220°
*d 2 to 7 mm (0.0787 to 0.276 in.)


Connect the water hose.

NOTICE:
·

Make sure that the clip is positioned as shown in the illustration.

·

Make sure to align the alignment marks of the hoses with the ribs of the inverter water pump assembly.

·

Do not remove the pieces of cloth or plastic bags from the pipe and disconnected hose until installation.




Hide G92A0A 2.INSTALL INVERTER RESERVE TANK ASSEMBLY

a.

Temporarily install the inverter reserve tank assembly with the 2 bolts.


b.
A259438
2.458,0.99 2.625,1.167 0.167,0.177 10 true 1 0.719,0.969 0.875,1.156 0.156,0.188 10 true 2

Tighten the 2 bolts in the order shown in the illustration.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)