Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SERVICE PLUG GRIP
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074898 SERVICE PLUG GRIP A

HYBRID / BATTERY CONTROL  SERVICE PLUG GRIP  INSTALLATION  


PROCEDURE

Hide G3834 1.INSTALL SERVICE PLUG GRIP

CAUTION:

Wear insulating gloves.


NOTICE:

Before connecting the service plug, check that no parts and tools remain and that the high voltage terminals and connectors are connected securely.


a.

Wear insulated gloves and install the service plug grip in the order shown in the illustration.

A258775


b.

Rotate the handle of the service plug grip 90° toward the battery and slide it in the direction shown by the arrow until a click sound is heard.


Hide G92QA 2.INSTALL NO. 8 HYBRID VEHICLE BATTERY SHIELD PANEL

a.

Install the No. 8 hybrid vehicle battery shield panel with the 2 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 64717A 3.INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER

Hide 64711 4.INSTALL LUGGAGE COMPARTMENT FLOOR MAT

Hide 5.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64718C 6.INSTALL LUGGAGE TRIM SERVICE HOLE COVER