30900
1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
31270
2.REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY
Using SST, hold the crankshaft pulley.
SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)
Remove the 6 bolts and transmission input damper assembly.
13405
3.REMOVE FLYWHEEL SUB-ASSEMBLY
Using SST, hold the crankshaft pulley.
SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)
Remove the 8 bolts and flywheel sub-assembly.
11401L
4.REMOVE REAR ENGINE OIL SEAL
| *a | Cut Position |
Using a knife, cut off the lip of the oil seal.
Using a screwdriver, pry out the oil seal.
Tape the screwdriver tip before use.
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.