Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › EGR COOLER
RM2040EQ _51 Engine / Hybrid System _014695 2AR-FXE EMISSION CONTROL _0074916 EGR COOLER A

2AR-FXE EMISSION CONTROL  EGR COOLER  INSTALLATION  


PROCEDURE

Hide 25680 1.INSTALL EGR COOLER ASSEMBLY

a.
A258463
0.906,1.802 1.104,1.99 0.198,0.188 10 true A 2.385,2.792 2.563,2.969 0.177,0.177 10 true A 1.063,3.958 1.26,4.156 0.198,0.198 10 true B 2.646,3.354 2.823,3.542 0.177,0.188 10 true B 0.875,0.656 1.063,0.844 0.188,0.188 10 true C 2.323,0.302 2.49,0.479 0.167,0.177 10 true C

Temporarily install 2 new gaskets and the EGR cooler assembly with the bolt (A) and nut (A).


b.

Using an E8 "TORX" socket wrench, install the stud bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


c.

Temporarily install the bolt (B) and nut (B).


d.

Temporarily install the 2 bolts (C).


e.

Tighten the 4 bolts and 2 nuts.

Torque:
Bolt (A) and Nut (A) : 21 N*m (214 kgf*cm, 15 ft.*lbf)
Bolt (B) and Nut (B) : 21 N*m (214 kgf*cm, 15 ft.*lbf)
Bolt (C) : 10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Make sure that all installation surfaces of the EGR cooler assembly are in even contact when tightening the bolts and nuts.



f.

Connect the water by-pass hose.


Hide 25051 2.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY