Home › Engine / Hybrid System › 2AR-FXE LUBRICATION › OIL PUMP
RM2040EQ _51 Engine / Hybrid System _014698 2AR-FXE LUBRICATION _0074936 OIL PUMP A

2AR-FXE LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.


PROCEDURE

Hide 82121 2.REMOVE ENGINE WIRE

Hide 11201 4.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

a.
A259132

Remove the 16 bolts, 3 seal washers, cylinder head cover and cylinder head cover gasket.


b.
A259133

Remove the 2 gaskets from the camshaft bearing caps.


Hide 11301K 5.REMOVE CRANKSHAFT POSITION SENSOR

Hide 12315A 7.REMOVE ENGINE MOUNTING BRACKET RH

a.
A259135

Remove the 5 bolts and engine mounting bracket RH.


Hide 8.REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

a.
A235204

Remove the 17 bolts and 2 nuts.


b.

Remove the timing chain cover by prying between the timing chain cover and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.

A283977
6.563,1.802 6.344,1.802 6.344,1.802 5.99,0.896 false 4.781,1.865 5.26,2.521 5.26,2.521 5.469,2.521 false 1.354,1.729 2.146,1.729 false 0.573,1.531 0.802,1.531 0.802,1.531 1.063,0.813 false 0.396,1.427 0.708,1.583 0.313,0.156 10 false *1 1.198,1.625 1.51,1.781 0.313,0.156 10 false *1 5.5,2.417 5.813,2.573 0.313,0.156 10 false *1 6.615,1.688 6.927,1.844 0.313,0.156 10 false *1
*1 Protective Tape - -


NOTICE:

Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase or chain cover.


HINT:

Tape the screwdriver tip before use.



c.
A196858

Remove the 3 gaskets from the stiffening crankcase.


Hide 11301C 9.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A210537
1.865,0.406 1.958,0.406 1.958,0.406 2.052,0.656 false 1.26,0.479 1.375,0.479 1.375,0.479 1.49,0.76 false 1.708,0.313 1.896,0.49 0.188,0.177 10 false *2 1.104,0.385 1.292,0.563 0.188,0.177 10 false *1
*1 Protective Tape
*2 Wooden Block


Using a screwdriver and wooden block, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole.


HINT:

Tape the screwdriver tip before use.