Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0074941 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P1578  Brake System Malfunction  


DESCRIPTION

This DTC is output when the electronically controlled brake system has a problem. Check the electronically controlled brake system when this DTC is output.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1578 Brake System Malfunction The power management control ECU receives a brake system error signal for 0.2 sec. or more while the cruise control is in operation
·

Electronically controlled brake system

·

Power management control ECU



WIRING DIAGRAM

E149011E52
2.146,0.574 2.548,0.734 0.402,0.161 10 CA1H 4.948,0.574 5.35,0.734 0.402,0.161 10 CA1H 2.146,1.078 2.548,1.239 0.402,0.161 10 CA1L 4.948,1.078 5.35,1.239 0.402,0.161 10 CA1L 2.618,0.41 2.892,0.594 0.274,0.184 10 37 2.618,0.914 2.962,1.098 0.344,0.184 10 38 4.682,0.41 4.875,0.603 0.193,0.193 10 25 4.682,0.914 4.875,1.108 0.193,0.193 10 24 0.778,1.515 1.082,1.69 0.304,0.175 10 A28 0.778,1.676 3.065,2.072 2.287,0.396 10 Brake Booster with Master Cylinder Assembly (Skid Control ECU) 4.813,1.615 5.059,1.783 0.247,0.168 10 I4 4.813,1.776 6.95,2.101 2.138,0.325 10 Power Management Control ECU 0.871,2.451 2.581,2.613 1.709,0.162 10 : CAN Communication Line

CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.


PROCEDURE

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / DTC.


e.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTC is not output A
DTC is output B




A

2.CHECK FOR DTCs (DTC P1578)

B

2.CHECK FOR DTCs (DTC P1578)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control system on using the cruise control switch (ON-OFF button).


iii.

Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.



e.

Enter the following menus: Powertrain / Cruise Control /DTC.


f.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 238
Result:
Result Proceed to
DTC is not output A
DTC P1578 is output B




A

B

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
a.

Replace the brake booster with master cylinder assembly (skid control ECU).

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER>REMOVAL


Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTCs (DTC P1578)
4.CHECK FOR DTCs (DTC P1578)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 238

e.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control system on using the cruise control switch (ON-OFF button).


iii.

Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.



f.

Enter the following menus: Powertrain / Cruise Control / DTC.


g.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 238
Result:
Result Proceed to
DTC is not output A
DTC P1578 is output B




A

END

B