Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › MOTOR WATER JACKET COVER ASSEMBLY
RM2040EQ _52 Drivetrain _014701 P314 HYBRID TRANSMISSION / TRANSAXLE _0074951 MOTOR WATER JACKET COVER ASSEMBLY A

P314 HYBRID TRANSMISSION / TRANSAXLE  MOTOR WATER JACKET COVER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 MOTOR WATER JACKET COVER ASSEMBLY

a.

Remove any remaining seal packing from the transaxle housing installation surface and bolt holes.

NOTICE:
·

Clean and degrease the installation surface and bolt holes.

·

Do not allow any remaining seal packing to enter the coolant path when cleaning.




b.
C245951

Apply seal packing in a continuous line as shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent


Standard seal diameter:

1.5 mm (0.059 in.) or more.


NOTICE:

Remove any oil from the contact surface.



c.

Install a new No. 1 motor water jacket cover assembly to the hybrid vehicle transaxle with 8 new bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Install the motor water jacket cover assembly within 3 minutes and tighten the bolts within 10 minutes after applying seal packing.

·

Do not add coolant within 2 hours after installing the motor water jacket cover assembly.

·

Do not start the engine for at least 2 hours after installing the motor water jacket cover assembly.




Hide 35151J 2.INSTALL AUTOMATIC TRANSMISSION CASE COVER

a.

Install the automatic transmission case cover to the hybrid vehicle transaxle with the 2 bolts and a new clip.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 33823 3.INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET

Hide 12311A 4.INSTALL FRONT ENGINE MOUNTING BRACKET

Hide 5.INSTALL NO. 2 MOTOR WATER JACKET COVER ASSEMBLY

a.

Remove any remaining seal packing from the transaxle housing installation surface and bolt holes.

NOTICE:
·

Clean and degrease the installation surface and bolt holes.

·

Do not allow any remaining seal packing to enter the coolant path when cleaning.




b.
C245952

Apply seal packing in a continuous line as shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent


Standard seal diameter:

1.5 mm (0.059 in.) or more.


NOTICE:

Remove any oil from the contact surface.



c.

Install a new No. 2 motor water jacket cover assembly to the hybrid vehicle transaxle with 5 new bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Install the motor water jacket cover assembly within 3 minutes and tighten the bolts within 10 minutes after applying seal packing.

·

Do not add coolant within 2 hours after installing the motor water jacket cover assembly.

·

Do not start the engine for at least 2 hours after installing the motor water jacket cover assembly.




Hide 30900 6.INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY