48818
1.INSTALL REAR STABILIZER BUSHING
| *a | Stopper Ring |
| *b | Cutout |
|
Rear of the Vehicle |
|
Outside of the Vehicle |
Install the 2 rear stabilizer bushings to the outside of the stopper ring on the rear stabilizer bar as shown in the illustration.
Install the rear stabilizer bushing so that the cutouts face rearward.
48832A
2.INSTALL REAR NO. 1 STABILIZER BAR BRACKET
Install the 2 rear No. 1 stabilizer bar brackets.
48812
3.INSTALL REAR STABILIZER BAR
|
Front of the Vehicle |
Install the rear stabilizer bar with the 4 bolts.
48840A
4.INSTALL REAR STABILIZER LINK ASSEMBLY LH
Install the rear stabilizer link assembly LH to the rear shock absorber assembly with the nut.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.
Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.
48830D
5.INSTALL REAR STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
58399B
6.INSTALL NO. 2 FLOOR UNDER COVER
58398H
7.INSTALL NO. 1 FLOOR UNDER COVER
8.INSTALL REAR WHEELS