Home › Suspension › REAR SUSPENSION › REAR STRUT ROD
RM2040EQ _53 Suspension _014706 REAR SUSPENSION _0074976 REAR STRUT ROD A

REAR SUSPENSION  REAR STRUT ROD  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48780A 1.TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

a.
C132496

Temporarily install the rear strut rod assembly (rear side) to the rear axle carrier sub-assembly with the bolt and nut.

NOTICE:

When temporarily tightening the bolt, keep the nut from rotating.


HINT:

Insert the bolt from the inside of the vehicle.



b.

Support the rear axle carrier sub-assembly with a jack and a wooden block.


c.

Connect the rear strut rod assembly (front side) with the bolt and nut.

NOTICE:

When temporarily tightening the bolt, keep the nut from rotating.



Hide 48780A 3.FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

a.

Fully tighten the bolt (rear side).

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)

NOTICE:

When fully tightening the bolt, keep the nut from rotating.



b.

Fully tighten the bolt (front side).

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)

NOTICE:

When fully tightening the bolt, keep the nut from rotating.



Hide 46430 4.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Connect the No. 3 parking brake cable assembly with the bolt.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 58399B 5.INSTALL NO. 2 FLOOR UNDER COVER

a.

Install the No. 2 floor under cover with the 6 nuts.

HINT:

The 6 nuts are attached to the No. 2 floor under cover.


Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


b.

Install the 2 clips.


Hide 58398H 6.INSTALL NO. 1 FLOOR UNDER COVER (for RH Side)

a.

Install the No. 1 floor under cover with the 6 nuts.

HINT:

The 6 nuts are attached to the No. 1 floor under cover.


Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


Hide 7.INSTALL REAR WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)