Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
42305
1.INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
Install the rear axle carrier sub-assembly to the rear shock absorber assembly with the 2 bolts and 2 nuts.
While keeping the bolts from rotating, tighten the nuts.
48720A
2.TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY
Temporarily tighten rear No. 1 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.
When temporarily tightening the bolt, keep the nut from rotating.
Insert the bolt from the front of the vehicle.
48740F
3.TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY
Temporarily tighten rear No. 2 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.
When temporarily tightening the bolt, keep the nut from rotating.
Insert the bolt from the rear of the vehicle.
48780A
4.TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY
Temporarily tighten rear strut rod assembly (rear side) to the rear axle carrier sub-assembly with the bolt and nut.
When temporarily tightening the bolt, keep the nut from rotating.
Insert the bolt from the inside of the vehicle.
42450B
5.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
89516D
6.CONNECT SKID CONTROL SENSOR WIRE
42431
7.INSTALL REAR DISC
42491
8.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
9.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
10.STABILIZE SUSPENSION
Install the rear wheel.
Lower the vehicle and bounce it up and down several times to stabilize the rear suspension. Raise the vehicle.
Remove the rear wheel.
48720A
11.FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY
Fully tighten the bolt (outer side).
Since a stopper nut is used, fully tighten the bolt.
48740F
12.FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY
Fully tighten the bolt (outer side).
Since a stopper nut is used, fully tighten the bolt.
48780A
13.FULLY TIGHTEN REAR STRUT ROD ASSEMBLY
Fully tighten the bolt
Since a stopper nut is used, fully tighten the bolt.
14.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
Connect the cable to the negative (-) auxiliary battery terminal.
Click herePower Source / Network>2AR-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION
Connect the reservoir level switch connector.
Clear the DTCs.
55702A
15.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY
16.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
17.ADJUST PARKING BRAKE
18.INSTALL REAR WHEEL
19.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
20.CHECK FOR SPEED SENSOR SIGNAL