Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM2040EQ _54 Brake _014708 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074981 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

Hide 53876A 3.REMOVE FRONT FENDER LINER

HINT:

Use the same procedure for the LH side and RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL


Hide 89543 4.REMOVE FRONT SPEED SENSOR

a.
C238451

Disconnect the connector and disengage the clamp.


b.
C238450

Remove the bolt and front speed sensor clamp from the body.


c.
C238449C07
1.479,0.313 1.677,0.313 false 0.979,0.792 0.844,0.792 0.844,0.792 0.708,1.052 false 1.708,0.219 1.99,0.448 0.281,0.229 10 false *1 0.563,1.01 0.896,1.281 0.333,0.271 10 false *2
*1 Front Speed Sensor Clamp
*2 Front Flexible Hose


Remove the bolt, front flexible hose and front speed sensor clamp together from the shock absorber assembly.


d.

Disengage the clamp from the front shock absorber assembly.


e.
C238448

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Prevent foreign matter from attaching to the front speed sensor tip.

·

Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.