Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2040EQ _54 Brake _014711 BRAKE (REAR) _0074992 REAR BRAKE G

BRAKE (REAR)  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring. If necessary, replace the rear disc brake cylinder assembly and/or piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C175529
2.01,0.813 2.458,0.365 2.458,0.365 2.688,0.365 false 2.708,0.281 3.01,0.552 0.302,0.271 10 false *1
*1 Ruler


Using a ruler, measure the pad lining thickness.

Standard thickness:

10.5 mm (0.413 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the pad lining thickness is less than the minimum, replace the brake pads.

HINT:

Be sure to check the wear of the rear disc when replacing the brake pads.



Hide 47716A 3.INSPECT REAR DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the rear disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are removed.

If necessary, replace the rear disc brake pad support plates.


Hide 4.INSPECT DISC THICKNESS

a.
C132819
1.875,1.708 2.052,1.979 2.052,1.979 2.167,1.979 false 2.177,1.896 2.448,2.125 0.271,0.229 10 false *1
*1 Micrometer


Using a micrometer, measure the disc thickness.

Standard thickness:

10.0 mm (0.394 in.)


Minimum thickness:

8.5 mm (0.335 in.)


If the disc thickness is less than the minimum, replace the rear disc.


Hide 5.INSPECT DISC RUNOUT

a.

Inspect the rear axle hub bearing looseness and axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>ON-VEHICLE INSPECTION


b.
C238507
2.042,1.135 1.854,0.917 1.854,0.917 1.542,0.917 false 1.281,0.833 1.74,1.156 0.458,0.323 10 false SST

While holding the disc using SST, tighten the disc with the 5 hub nuts.

SST
09330-00021  

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)


c.
C190569
1.896,0.99 2.125,0.99 false 2.146,0.917 2.396,1.188 0.25,0.271 10 false *1
*1 Dial Indicator


Using a dial indicator with magnetic base, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.

Maximum disc runout:

0.15 mm (0.00591 in.)


NOTICE:

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.


If the runout exceeds the maximum value, change the installation position of the disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the disc. If the disc thickness is less than the minimum, replace the rear disc.


d.

Remove the 5 nuts and rear disc.