1. CHECK STEERING EFFORT (TORQUE)
Stop the vehicle on a level, paved surface and align the wheels straight ahead.
Remove the horn button assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>REMOVAL
Connect the cable to the negative (-) auxiliary battery terminal.
Using a torque wrench, check that the steering wheel set nut is properly tightened.
Turn the power switch on (READY) so that the power steering is ready to operate.
Turn the steering wheel 90 degrees to the right and check the steering effort (torque) while continuing to turn it further in the same direction.
6.0 N*m (61 kgf*cm, 53 in.*lbf) or less
Align the front wheels facing straight ahead.
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Install the horn button assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>INSTALLATION