Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2012.02–2015.04
RM2040EQ _58 Vehicle Interior _014727 SUPPLEMENTAL RESTRAINT SYSTEMS _0075079 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


PROCEDURE

Hide 45130 1.INSTALL HORN BUTTON ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B289015C02
0.438,2.094 1.552,2.094 false 2.323,2.438 2.5,2.698 2.5,2.698 2.927,2.698 false 0.958,0.271 0.917,0.229 0.917,0.229 0.656,0.229 false 0.292,2.01 0.49,2.219 0.198,0.208 10 false *1 2.948,2.604 3.177,2.844 0.229,0.24 10 false *2 0.51,0.146 0.698,0.323 0.188,0.177 10 false *3
*1 Airbag Connector
*2 Horn Connector
*3 Airbag Connector Lock


Connect the airbag connector to the horn button assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the lock to install the airbag connector.


e.

Connect the horn connector to the horn button assembly.


f.
B312066

Push the horn button assembly to engage the 3 pins carefully.

NOTICE:
·

Make sure that the pins are securely inserted into the steering holes.

·

Make sure to engage the 2 upper pins first.

·

Make sure that the horn button assembly is securely installed.




Hide 45187 2.INSTALL LOWER NO. 3 STEERING WHEEL COVER

a.

Engage the claw and guide to install the lower No. 3 steering wheel cover.


Hide 45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.

Engage the claw and guide to install the lower No. 2 steering wheel cover.


Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 64718C 5.INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Hide 45130 6.INSPECT HORN BUTTON ASSEMBLY

a.

Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system (Click hereVehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).