If the power steering ECU assembly stores these DTCs, it will shut off the motor relay circuit (built into the power steering ECU assembly) and stop power assist. However, power assist continues if DTC C1533/25 or C1534/25 is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition |
|---|---|---|---|---|---|
| C1521/25 | Short in Motor Circuit | Motor overcurrent | Power steering ECU assembly | EPS Warning Light: Comes on | Power switch on (IG) again |
| C1531/25 | ECU Malfunction | ECU internal malfunction (CPU malfunction) | Power steering ECU assembly | EPS Warning Light: Comes on | Power switch on (IG) again |
| C1532/25 | ECU Malfunction | ECU internal malfunction (Peripheral circuit malfunction) | Power steering ECU assembly | EPS Warning Light: Comes on | Power switch on (IG) again |
| C1533/25 | Temperature Sensor Circuit is Low or High | ECU internal malfunction (Substrate temperature sensor malfunction) | Power steering ECU assembly | EPS Warning Light: Does not come on | After normal judgment |
| C1534/25 | EEPROM Malfunction | ECU internal malfunction (EEPROM error) | Power steering ECU assembly | EPS Warning Light: Set with default value and it continues the control. In this case, the warning light illuminates. | After normal judgment |
If the power steering ECU assembly has been replaced, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Clear the DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs (except C1521/25, C1531/25, C1532/25, C1533/25 and C1534/25 DTC) are not output. | A |
| DTCs (except C1521/25, C1531/25, C1532/25, C1533/25 and C1534/25 DTC) are output. | B |
A
B