The power steering ECU assembly distinguishes the power switch status as on (IG) or off through the IG power source circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition |
|---|---|---|---|---|---|
| C1551/25 | IG Power Supply Voltage Malfunction | IG power source circuit malfunction inside ECU | ·
EPS-IG1 fuse ·
IG power source circuit ·
ECU wire sub-assembly ·
Power steering ECU assembly |
EPS Warning Light: Comes on | Power switch on (IG) again or after normal confirmation |
If the power steering ECU assembly has been replaced, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the connection condition of the ECU wire sub-assembly and power steering ECU assembly connectors.
The ECU wire sub-assembly and power steering ECU assembly connectors are securely connected.
Check that the ground wire is securely installed with the bolt.
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>INSTALLATION
The ground wire is securely installed with the bolt.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "IG power supply" in the Data List and read the value displayed on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| IG Power Supply | IG power source voltage | Min.: 0.0000 V
Max.: 20.1531 V |
Power switch on (IG): 9 to 16 V | - |
| Tester Display |
|---|
| IG Power Supply |
The normal condition value is displayed on the intelligent tester.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector
(to ECU Wire Sub-assembly) |
Disconnect the Ij2 connector from the ECU wire sub-assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Ij2-5 (IG) - Body ground | Power switch on (IG) | 9 to 16 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Connect the Ij2 connector to the ECU wire sub-assembly.
Disconnect the power steering ECU assembly j3 and j2 connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| j3-1 (IG) - Body ground | Power switch on (IG) | 9 to 16 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| j2-2 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG