Home › Steering › STEERING COLUMN › STEERING WHEEL › 2012.02–2015.04
RM2040EQ _55 Steering _014714 STEERING COLUMN _0075003 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 45713A 1.INSTALL STEERING SHAKE DAMPER

a.

Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


Hide 84633 2.INSTALL CRUISE CONTROL SWITCH WIRE

a.

Install the cruise control switch wire.


Hide 84250A 4.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 5.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 6.INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 7.INSTALL STEERING WHEEL ASSEMBLY

a.
C252573C02
1.698,0.438 0.615,0.438 false 1.698,0.656 0.698,0.656 0.698,0.656 0.698,0.438 false 0.458,0.333 0.719,0.615 0.26,0.281 10 false *a
*a Matchmark


Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.


Hide 8.CHECK STEERING WHEEL CENTER POINT

Hide 45130 9.INSTALL HORN BUTTON ASSEMBLY