1. PRECAUTION
When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
2.INSTALL NAVIGATION ECU SUB-ASSEMBLY
55900
3.INSTALL AIR CONDITIONING CONTROL ASSEMBLY
4.INSTALL HARD DISK DRIVE
86211J
5.INSTALL NO. 1 RADIO RECEIVER BRACKET
Install the No. 1 radio receiver bracket with the 5 screws.
86212C
6.INSTALL NO. 2 RADIO RECEIVER BRACKET
Install the No. 2 radio receiver bracket with the 5 screws.
7.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
Connect each connector.
Engage the 8 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.
Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.
55660
8.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
9.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
58804A
10.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
58916
11.INSTALL BOX BOTTOM MAT
12.INSTALL REAR CONSOLE BOX ASSEMBLY
13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
64718C
14.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
15.INSPECT HARD DISK DRIVE