Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075027 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


PROCEDURE

Hide 88173 1.INSTALL BLIND SPOT MONITOR COVER

a.

Engage the claw.


b.

Install the blind spot monitor cover with the 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88172 2.INSTALL BLIND SPOT MONITOR SENSOR

a.
E226441C02
1.719,0.625 2.229,0.448 false 1.927,3.698 2.156,4.063 false 2.281,0.313 2.594,0.521 0.313,0.208 10 *1 0.219,2.469 0.521,2.74 0.302,0.271 12 *B 0.177,0.094 0.458,0.344 0.281,0.25 12 *A 2.188,4.052 2.521,4.292 0.333,0.24 10 *1
*A for RH Side:
*B for LH Side:
*1 Identification Mark


Connect the connector.

NOTICE:
·

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.

·

Confirm the identification marks on the blind spot monitor sensor before installing it.

·

If the blind spot monitor sensors are not installed to the correct side, the blind spot monitor system will not operate.




b.

Install the blind spot monitor sensor with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

for LH Side:

i.

Engage the 2 clamps.



d.

for RH Side:

i.

Engage the clamp.



Hide 3.INSTALL REAR BUMPER ASSEMBLY

Hide 4. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

a.

Refer to operation check.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

SST
09870-60000  (09870-60010)
09870-60040