Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY
RM2040EQ _57 Power Source / Network _014720 POWER DISTRIBUTION _0075040 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82662A 4.REMOVE NO. 1 RELAY BLOCK COVER

a.
B286753

Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.


Hide 82720 5.REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY

a.

Disengage the 2 claws as shown in the illustration.

B286757C01
4.427,1.396 4.656,1.573 0.229,0.177 4.219,1.583 4.417,1.51 false 6.323,2.448 6.146,2.49 false 5.844,1.396 6.677,1.396 false 5.99,2.406 6.167,2.573 0.177,0.167 10 *a 4.448,1.427 4.604,1.563 0.156,0.135 10 *1 6.729,1.333 7.042,1.49 0.313,0.156 10 *1
*1 Protective Tape - -
*a Pulled Position - -



b.

Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.

NOTICE:

When pulling a engine room junction block assembly, take care not to damage the engine room junction block assembly.


HINT:

Tape the pliers tip before use.



c.
B286754

Disconnect the 2 connectors and remove the engine room junction block assembly.

NOTICE:
·

Do not drop or allow any impact on parts.

·

Do not touch the connector.