These DTCs are stored when there is a CAN communication error between the power management control ECU and the certification ECU (smart key ECU assembly).
When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| U0100 | Lost Communication with ECM | CAN communication error between the certification ECU (smart key ECU assembly) and ECM (1-trip detection*) | ECM | DTC Output Confirmation Operation
Turn the power switch on (IG) and wait 10 seconds or more. |
| U0140 | Lost Communication with Main Body ECU | CAN communication error between the power management control ECU and main body ECU (1-trip detection*) | Main body ECU (multiplex network body ECU) | DTC Output Confirmation Operation
Always |
| U0142 | Lost Communication with Main Body ECU | CAN communication error between the certification ECU (smart key ECU assembly) and main body ECU (1-trip detection*) | Main body ECU (multiplex network body ECU) | DTC Output Confirmation Operation
Always |
| U0155 | Lost Communication with Combination Meter | CAN communication error between the power management control ECU or certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection*) | Combination meter assembly | DTC Output Confirmation Operation
Turn the power switch on (IG) and wait 10 seconds or more. |
| U0293 | Lost Communication with HV ECU | CAN communication error between the certification ECU (smart key ECU assembly) and power management control ECU (1-trip detection*) | Power management control ECU | DTC Output Confirmation Operation
Turn the power switch on (IG) and wait 10 seconds or more. |
*: Only detected while a malfunction is present and the power switch is on (IG)
| DTC Code | Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|---|
| U0100 | There is no effect on vehicle behavior. | - |
| U0140 | The warning (meter buzzer) does not sound and the meter does not indicate a warning. | - |
| U0142 | ·
Doors cannot be locked or unlocked. The warning (wireless buzzer) does not sound. ·
The warning (meter buzzer) does not sound and the meter does not indicate a warning. |
- |
| U0155 | ·
The warning (meter buzzer) does not sound and the meter does not indicate a warning. (When the smart key ECU stores the DTC.) ·
There is no effect on vehicle behavior. (When the power management control ECU stores the DTC.) |
- |
| U0293 | The warning (meter buzzer) does not sound and the meter does not indicate a warning. | - |
When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle, select the vehicle type under manual mode, and then enter the following menus:
for Power Source Control: Body / Power Source Control / DTC.
for Entry&Start: Body / Entry&Start / DTC.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
| DTC | Data List Item | Active Test Item |
|---|---|---|
| U0100
U0140 U0142 U0155 U0293 |
- | - |
Note any DTCs that are output.
| Proceed to |
|---|
| NEXT |
NEXT
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING