The engine hood courtesy switch is installed together with the hood lock. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Hood Courtesy SW | Engine hood courtesy switch | ON or OFF | ON: Engine hood open
OFF: Engine hood closed |
- |
| Tester Display |
|---|
| Hood Courtesy SW |
The indicator on the intelligent tester switches between ON and OFF in accordance with the engine hood courtesy switch (hood lock assembly) status.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3D-25 - MB-20 (HCTY) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the hood lock assembly.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| *1 | Opened | *2 | Locked |
| *a | Component without harness connected
(Engine Hood Courtesy Switch (Hood Lock Assembly)) |
- | - |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Opened | 10 kΩ or higher |
| 1 - 2 | Locked | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2-1 - 3D-25 | Always | Below 1 Ω |
| A2-1 - Body ground | Always | 10 kΩ or higher |
| A2-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG