Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat)
RM2040EQ _58 Vehicle Interior _014728 SEAT _0075090 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

If the side airbag has deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.



NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72137J 4.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

a.

Operate the slide and vertical power seat switch knob and move the seat to the foremost position.


b.
B281488

Disengage the 2 claws to remove the rear outer seat track bracket cover.


Hide 72157C 5.REMOVE REAR INNER SEAT TRACK BRACKET COVER

a.
B311809

Disengage the 2 claws to remove the rear inner seat track bracket cover.


Hide 6.REMOVE FRONT SEAT ASSEMBLY

a.
B286550

Remove the 2 bolts on the rear side of the seat.


b.

Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.


c.
B286548

Remove the 2 bolts on the front side of the seat.


d.

Operate the slide and vertical power seat switch knob and move the seat to the center position. Then, operate the reclining power seat switch knob and move the seatback to the upright position.


e.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



f.

Disconnect each connector and clamp under the seat.


g.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.