Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2040EQ _58 Vehicle Interior _014729 SEAT BELT _0075103 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67913 4.REMOVE FRONT DOOR SCUFF PLATE

Hide 62311B 5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the front door opening trim weatherstrip.


Hide 67917A 6.REMOVE REAR DOOR SCUFF PLATE

Hide 62331A 7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the rear door opening trim weatherstrip.


Hide 73233 8.REMOVE LAP BELT OUTER ANCHOR COVER

a.
B279488

Disengage the 3 claws and remove the lap belt outer anchor cover.


Hide 73210 9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B279489

Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.


Hide 62413A 10.REMOVE CENTER PILLAR LOWER GARNISH

Hide 62411B 11.REMOVE CENTER PILLAR UPPER GARNISH

Hide 73210 12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B279490

Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.


b.
B307666C01
0.677,3.396 0.938,3.396 false 0.479,3.292 0.76,3.542 0.281,0.25 10 false *1
*1 Protective Tape


Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



c.
B307667

Remove the 2 bolts and front seat outer belt assembly.


Hide 73200A 13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

a.
B279493

Remove the 2 bolts.


b.

Disengage the guide and remove the front shoulder belt anchor adjuster assembly.