Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM2040EQ _59 Vehicle Exterior _014733 WINDOW / GLASS _0075139 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 85720E 1.INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

Hide 2.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Hide 67673A 3.INSTALL REAR DOOR FRAME GARNISH

Hide 68103 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68123B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS

a.
B287025

Install the rear door quarter window glass together with the rear door quarter window weatherstrip in the direction indicated by the arrow in the illustration.


Hide 67407F 6.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68142C 7.INSTALL REAR DOOR GLASS RUN

Hide 67871 8.INSTALL REAR DOOR WEATHERSTRIP

a.
B294437

Install the upper part of rear door weatherstrip as shown in the illustration.


Hide 67841E 9.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68173B 10.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67603 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74250 12.INSTALL REAR ARMREST ASSEMBLY

Hide 13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69283A 14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 15.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 16.INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Hide 17.INITIALIZE POWER WINDOW CONTROL SYSTEM