Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69283A
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74250
6.REMOVE REAR ARMREST ASSEMBLY
67603
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68173B
8.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67841E
9.REMOVE REAR DOOR SERVICE HOLE COVER
67871
10.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the upper part of rear door weatherstrip as shown in the illustration.
68142C
11.REMOVE REAR DOOR GLASS RUN
67407F
12.REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
68123B
13.REMOVE REAR DOOR QUARTER WINDOW GLASS
Remove the rear door quarter window glass with the rear door quarter window weatherstrip as shown in the illustration.
68103
14.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
67673A
15.REMOVE REAR DOOR FRAME GARNISH
16.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
85720E
17.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY